The ball should be:
- Shaped round.
- Made of leather or other materials.
- Minimum and maximum diameter of 62 cm 64 cm.
- Weight ball when the game starts at a minimum of 400 grams and 440 grams maximum.
- The pressure is equal to 0.4 to 0.6 atmospheres (400-600 g / cm ³).
BROKEN BULB REPLACEMENT
If the ball is cracked or damaged in a game:
- The game is paused.
- The game started again by dropping the replacement ball at the spot where the first ball is damaged.
If the ball breaks or becomes damaged when the ball is not in the game when the game starts, goal kick, corner kick, free kick, penalty kick or a kick in:
- The game started back in accordance with the ordinary rules.
- The ball can not be replaced during the match without the permission of the referee.
DECISION 1
Ball of leather laken / fur (felt balls) is not allowed.
DECISION 2
The ball may not bounce less than 55 cm and not more than 65 cm on first bounce when dropped from a height of 2 m. In a game or competition, only balls that meet the minimum technical requirements stipulated in Rule # 2 is allowed to be used.
In a game or competition of FIFA and other games under the supervision of the confederation, use Futsal ball logo depends on three requirements listed on the ball:
The official logo of "FIFA APPROVED" or "FIFA INSPECTED" or references "International Match Ball Standard"
The logo is printed on the ball that the ball has been tested officially and in accordance with technical requirements, each different category specifications set out in Rule 2, a list of additional requirements specified in each category issued by FIFA. The institution appointed by FIFA who will conduct the test.
National Association may approve the use of ball to be used for the competition itself or the entire competition was held, the ball used must satisfy one of three pre-defined requirements of Rule # 2
If the national association to allow the use of balls bearing the "FIFA APPROVED" or "FIFA INSPECTED" for the competition itself, the national association should also be allowed the use of a ball that holds the royalty-free design "Matchball International Standard".
In FIFA competition and other competitions under the supervision of confederations and national associations, are not allowed any form of commercial advertising printed on the ball, except for the poster competition, the organizers of the competition as well as manufacturers' trademarks by limiting the size and number of these signs.
Ball of leather laken / fur (felt balls) is not allowed.
DECISION 2
The ball may not bounce less than 55 cm and not more than 65 cm on first bounce when dropped from a height of 2 m. In a game or competition, only balls that meet the minimum technical requirements stipulated in Rule # 2 is allowed to be used.
In a game or competition of FIFA and other games under the supervision of the confederation, use Futsal ball logo depends on three requirements listed on the ball:
The official logo of "FIFA APPROVED" or "FIFA INSPECTED" or references "International Match Ball Standard"
The logo is printed on the ball that the ball has been tested officially and in accordance with technical requirements, each different category specifications set out in Rule 2, a list of additional requirements specified in each category issued by FIFA. The institution appointed by FIFA who will conduct the test.
National Association may approve the use of ball to be used for the competition itself or the entire competition was held, the ball used must satisfy one of three pre-defined requirements of Rule # 2
If the national association to allow the use of balls bearing the "FIFA APPROVED" or "FIFA INSPECTED" for the competition itself, the national association should also be allowed the use of a ball that holds the royalty-free design "Matchball International Standard".
In FIFA competition and other competitions under the supervision of confederations and national associations, are not allowed any form of commercial advertising printed on the ball, except for the poster competition, the organizers of the competition as well as manufacturers' trademarks by limiting the size and number of these signs.
No comments:
Post a Comment